#include <devices/8254.h>
#include <palacios/vmm.h>
#include <palacios/vmm_time.h>
+#include <palacios/vmm_util.h>
+
+
+
+
+
+
// constants
#define OSC_HZ 1193182
/* The order of these typedefs is important because the numerical values correspond to the
* values coming from the io ports
*/
-typedef enum {NOT_RUNNING, WAITING_LOBYTE, WAITING_HIBYTE, RUNNING} channel_access_state_t;
+typedef enum {NOT_RUNNING, PENDING, RUNNING} channel_run_state_t;
+typedef enum {NOT_WAITING, WAITING_LOBYTE, WAITING_HIBYTE} channel_access_state_t;
typedef enum {LATCH_COUNT, LOBYTE_ONLY, HIBYTE_ONLY, LOBYTE_HIBYTE} channel_access_mode_t;
typedef enum {IRQ_ON_TERM_CNT, ONE_SHOT, RATE_GEN, SQR_WAVE, SW_STROBE, HW_STROBE} channel_op_mode_t;
struct channel {
channel_access_mode_t access_mode;
channel_access_state_t access_state;
+ channel_run_state_t run_state;
channel_op_mode_t op_mode;
-
// Time til interrupt trigger
ushort_t counter;
+/*
+ * This should call out to handle_SQR_WAVE_tics, etc...
+ */
+// Returns true if the the output signal changed state
+static int handle_crystal_tics(struct vm_device * dev, struct channel * ch, uint_t oscillations) {
+ uint_t channel_cycles = 0;
+ uint_t output_changed = 0;
+
+ PrintDebug("8254 PIT: %d crystal tics\n", oscillations);
+ if (ch->run_state == PENDING) {
+ oscillations--;
+ ch->counter = ch->reload_value;
+ ch->run_state = RUNNING;
+ } else if (ch->run_state != RUNNING) {
+ return output_changed;
+ }
+
+
+ PrintDebug("8254 PIT: Channel Run State = %d, counter=", ch->run_state);
+ PrintTraceLL(ch->counter);
+ PrintDebug("\n");
+
+
+ if (ch->counter > oscillations) {
+ ch->counter -= oscillations;
+ return output_changed;
+ } else {
+ oscillations -= ch->counter;
+ ch->counter = 0;
+ channel_cycles = 1;
+
+
+ channel_cycles += oscillations / ch->reload_value;
+ oscillations = oscillations % ch->reload_value;
+
+ ch->counter = ch->reload_value - oscillations;
+ }
+
+ PrintDebug("8254 PIT: Channel Cycles: %d\n", channel_cycles);
+
+
+
+ switch (ch->op_mode) {
+ case IRQ_ON_TERM_CNT:
+ if ((channel_cycles > 0) && (ch->output_pin == 0)) {
+ ch->output_pin = 1;
+ output_changed = 1;
+ }
+ break;
+ case ONE_SHOT:
+ if ((channel_cycles > 0) && (ch->output_pin == 0)) {
+ ch->output_pin = 1;
+ output_changed = 1;
+ }
+ break;
+ case RATE_GEN:
+ // See the data sheet: we ignore the output pin cycle...
+ if (channel_cycles > 0) {
+ output_changed = 1;
+ }
+ break;
+ case SQR_WAVE:
+ break;
+ case SW_STROBE:
+ break;
+ case HW_STROBE:
+ break;
+ default:
+ break;
+ }
+
+ return output_changed;
+}
+
static void pit_update_time(ullong_t cpu_cycles, ullong_t cpu_freq, void * private_data) {
- PrintDebug("Adding %d cycles\n", cpu_cycles);
+ struct vm_device * dev = (struct vm_device *)private_data;
+ struct pit * state = (struct pit *)dev->private_data;
+ // ullong_t tmp_ctr = state->pit_counter;
+ ullong_t tmp_cycles;
+ uint_t oscillations = 0;
+
+
+ /*
+ PrintDebug("updating cpu_cycles=");
+ PrintTraceLL(cpu_cycles);
+ PrintDebug("\n");
+
+ PrintDebug("pit_counter=");
+ PrintTraceLL(state->pit_counter);
+ PrintDebug("\n");
+
+ PrintDebug("pit_reload=");
+ PrintTraceLL(state->pit_reload);
+ PrintDebug("\n");
+ */
+
+ if (state->pit_counter > cpu_cycles) {
+ // Easy...
+ state->pit_counter -= cpu_cycles;
+ } else {
+
+ // Take off the first part
+ cpu_cycles -= state->pit_counter;
+ state->pit_counter = 0;
+ oscillations = 1;
+
+ if (cpu_cycles > state->pit_reload) {
+ // how many full oscillations
+ tmp_cycles = cpu_cycles;
+
+ cpu_cycles = do_divll(tmp_cycles, state->pit_reload);
+
+ oscillations += tmp_cycles;
+ }
+
+ // update counter with remainder (mod reload)
+ state->pit_counter = state->pit_reload - cpu_cycles;
+
+ //PrintDebug("8254 PIT: Handling %d crystal tics\n", oscillations);
+ if (handle_crystal_tics(dev, &(state->ch_0), oscillations) == 1) {
+ // raise interrupt
+ PrintDebug("8254 PIT: Injecting Timer interrupt to guest\n");
+ dev->vm->vm_ops.raise_irq(dev->vm, 0);
+ }
+
+ //handle_crystal_tics(dev, &(state->ch_1), oscillations);
+ //handle_crystal_tics(dev, &(state->ch_2), oscillations);
+ }
+
+
+
return;
}
+
+/* This should call out to handle_SQR_WAVE_write, etc...
+ */
static int handle_channel_write(struct channel * ch, char val) {
- // switch (ch->access_mode) {
+
+ switch (ch->access_state) {
+ case WAITING_HIBYTE:
+ {
+ ushort_t tmp_val = ((ushort_t)val) << 8;
+ ch->reload_value &= 0x00ff;
+ ch->reload_value |= tmp_val;
+
+
+ if ((ch->op_mode != RATE_GEN) || (ch->run_state != RUNNING)){
+ ch->run_state = PENDING;
+ }
+
+ if (ch->access_mode == LOBYTE_HIBYTE) {
+ ch->access_state = WAITING_LOBYTE;
+ }
+
+ PrintDebug("8254 PIT: updated channel counter: %d\n", ch->reload_value);
+ PrintDebug("8254 PIT: Channel Run State=%d\n", ch->run_state);
+ break;
+ }
+ case WAITING_LOBYTE:
+ ch->reload_value &= 0xff00;
+ ch->reload_value |= val;
+
+ if (ch->access_mode == LOBYTE_HIBYTE) {
+ ch->access_state = WAITING_HIBYTE;
+ } else if ((ch->op_mode != RATE_GEN) || (ch->run_state != RUNNING)) {
+ ch->run_state = PENDING;
+ }
+
+ PrintDebug("8254 PIT: updated channel counter: %d\n", ch->reload_value);
+ PrintDebug("8254 PIT: Channel Run State=%d\n", ch->run_state);
+ break;
+ default:
+ return -1;
+ }
- //}
+ switch (ch->op_mode) {
+ case IRQ_ON_TERM_CNT:
+ ch->output_pin = 0;
+ break;
+ case ONE_SHOT:
+ ch->output_pin = 1;
+ break;
+ case RATE_GEN:
+ ch->output_pin = 1;
+ break;
- return -1;
+ default:
+ return -1;
+ break;
+ }
+
+
+ return 0;
}
ch->op_mode = cmd.op_mode;
ch->access_mode = cmd.access_mode;
+
+
+
switch (cmd.access_mode) {
case LATCH_COUNT:
return -1;
case RATE_GEN:
ch->output_pin = 1;
break;
+ case SQR_WAVE:
+ ch->output_pin = 1;
+ break;
default:
return -1;
}
return -1;
}
- PrintDebug("8254 PIT: Write to PIT Channel %d\n", port - CHANNEL0_PORT);
+ PrintDebug("8254 PIT: Write to PIT Channel %d (%x)\n", port - CHANNEL0_PORT, *(char*)src);
switch (port) {
struct pit_cmd_word * cmd = (struct pit_cmd_word *)src;
PrintDebug("8254 PIT: Write to PIT Command port\n");
-
+ PrintDebug("8254 PIT: Writing to channel %d (access_mode = %d, op_mode = %d)\n", cmd->channel, cmd->access_mode, cmd->op_mode);
if (length != 1) {
PrintDebug("8254 PIT: Write of Invalid length to command port\n");
return -1;
};
+static void init_channel(struct channel * ch) {
+ ch->run_state = NOT_RUNNING;
+ ch->access_state = NOT_WAITING;
+ ch->access_mode = 0;
+ ch->op_mode = 0;
+
+ ch->counter = 0;
+ ch->reload_value = 0;
+ ch->output_pin = 0;
+ ch->gate_input_pin = 0;
+
+ return;
+}
+
+
static int pit_init(struct vm_device * dev) {
+ struct pit * state = (struct pit *)dev->private_data;
+ uint_t cpu_khz = V3_CPU_KHZ();
+ ullong_t reload_val = (ullong_t)cpu_khz * 1000;
+
dev_hook_io(dev, CHANNEL0_PORT, &pit_read_channel, &pit_write_channel);
dev_hook_io(dev, CHANNEL1_PORT, &pit_read_channel, &pit_write_channel);
dev_hook_io(dev, CHANNEL2_PORT, &pit_read_channel, &pit_write_channel);
dev_hook_io(dev, COMMAND_PORT, NULL, &pit_write_command);
+ PrintDebug("8254 PIT: OSC_HZ=%d, reload_val=", OSC_HZ);
+ PrintTraceLL(reload_val);
+ PrintDebug("\n");
+
v3_add_timer(dev->vm, &timer_ops, dev);
// Get cpu frequency and calculate the global pit oscilattor counter/cycle
+ do_divll(reload_val, OSC_HZ);
+ state->pit_counter = reload_val;
+ state->pit_reload = reload_val;
+
+
+
+ init_channel(&(state->ch_0));
+ init_channel(&(state->ch_1));
+ init_channel(&(state->ch_2));
+
+ PrintDebug("8254 PIT: CPU MHZ=%d -- pit count=", cpu_khz / 1000);
+ PrintTraceLL(state->pit_counter);
+ PrintDebug("\n");
return 0;
}